How To Change Your Radiator’s Valve

Photo:AttributionShare Alike Some rights reserved by F. D. Richards

Changing a radiator valve on your car can be hard and dirty work. However, if you follow these steps carefully, there should be no problems replacing the valve.

Steps

  1. Take off the radiator cap and turn the drain valve that is at the bottom of the radiator with a wrench to drain the radiator.
  2. Find the radiator hose and take it off with a flathead screwdriver.
  3. Expose the thermostat by removing the bolts on both sides of the thermostat with a wrench.
  4. Scrape the bottom of the thermostat housing and where the housing meets the surface with a gasket scraper.
  5. Put on the new thermostat and then once in place, on both sides of the newly replaced thermostat gasket, put gasket sealer on. Put the housing over the thermostat and then tighten the bolts with a wrench.
  6. Put the upper radiator hose on the housing of the thermostat and tighten the clamp with a screwdriver. Make sure to close the radiator’s drain valve by turning it clockwise with a wrench and fill the radiator with antifreeze.
  7. Put the radiator cap back on.

Article provided by wikiHow, a wiki that is building the world’s largest and highest quality how-to manual. Please edit this article and find author credits at the original wikiHow article on How to Change a Radiator Valve. Content on wikiHow can be shared under a Creative Commons License.

Share in...

    You must be logged in to post a comment Login